The motor may need to be reset if there is a power spike a load that is unbalanced or a disruption in power.
Ge front load washer door lock light on.
Nbsp this may be the issue.
Whatever the model if your machine is stuck in a cycle try to reset the ge washer first.
Verify the water is turned on and restore power.
I tested the wax motor with an ohm meter and it appears to be ok.
Be used when the machine is locked.
I have a front loading washer that wont run on any cycle.
After successfully completing one load the machine now has developed a glitch.
My ge front loading washing machine has a red lock light flashing.
A sound is made to indicate the lock unlock status.
Ge front loader door will not lock to start the cycle.
Someone not familiar with my front loading ge washing machine tried to turn it on pressing god knows what.
The powerbutton can stil.
Download a copy of the owner s manual.
Pull down on it and the door will open.
Press and hold the lock button for 3 seconds.
I remove the door lock assembly and pulled the cover off.
To unlock the washer controls press and hold the delay start button for 3 seconds.
By patti pittsburgh pa my ge frontloader washer is only 2 years old.
The control lock icon on the display will light up when it is on.
The door lock light does come on but the door will not lock.
When i go to start the washer the door lock light comes on but it does not lock the door therefore the washer will not start.
To lock the washer press nbsp and hold the delay startbutton for 3 seconds.
See also the owner s manual for specific washer model.
I have a whirlpool 6th sense 7 5 kg front load washing machine.
This should resolve the issue.
To correct the situation shut off the circuit breaker for 30 seconds or unplug the washer then turn the timer knob around and back to any position other than final spin.
Pull the lower panel out at the bottom and remove it.
You can unlock the unit by removing the three screws at the bottom front of the unit.
Step 3 lift up the top and locate the lid switch on the underside of the top.
Insert a putty knife between the front cabinet and top of the washing machine approximately 6 inches from each side to release the spring clips.
Reach up inside of the unit near where the door lock is and you will feel a small tab at the bottom of the lock assembly.
What does that mean.
The power button can still be used when the machine is locked.
The control lock icon on the display will light up when it is on.
The pause can happen for several reasons including a power failure or if the stop pause button was pressed to pause the cycle and not reset.
For other models of ge washing machines a pause in a cycle will cause the electronic controls to lock up.